Caractéristiques Techniques |
04 76 03 10 10 www.hfi.fr |
General
Half-duplex Radio-Telephone interface unit
Power: 10 to 16 V 150mA Power protection: resettable fuse, chock coil, over voltage clamp Power connector : 10 points removable screw connector Power connector wire size : 0.14mm² to 1.5mm² Temperature: 0 à 65°C Relative Humidity : 60% Size : w100 x h115 x d55 mm (d65 with connector) Weight : 260g Data retention: Non volatile Flash Memory Approvals : ROHS CE qualification for EMC directive 2004/108/CE EN 61000-6-4 IEC 61000-6-4 EN 61000-6-2 IEC 61000-6-2 EN 61000-4-2 IEC 61000-4-2 EN 61000-4-3 IEC 61000-4-3 EN 61000-4-4 IEC 61000-4-4 EN 61000-4-6 IEC 61000-4-6
Software: PC configuration software runs under Windows XP, Windows Seven (32 et 64 bits)
Audio Messages: Total capacity : 8 minutes Application messages: 11 messages of 47 sec Record from microphone, PC (wav files), radio or telephone Radio and telephone gains separately adjustable
___________________________________________
Telephone interface
Connector: 4 points removable screw connector ( 2 wire used for line) Connector Wire size : 0.2mm² to 2.5mm² Analogue line type : PSTN Q.23 DTMF transceiver Ring signal detect : 25 Vac Programmable number of rings before answer: 0-99
LED: line presence (DC voltage > 22V , flashing if not connected), ring detection
Rx gain : adjustable from -20dB to 20dB Tx gain : adjustable from -33dB to 6dB Message gain: adjustable from -20dB to 8dB
Code DTMF sent by radio to connect the line: up to 8 DTMF codes Code DTMF sent by the radio to disconnect the line: up to 8 DTMF codes
Programmable ring time (1/100sec) Programmable disconnect tone duration (1/100sec) Programmable flashing time (1/100sec)
___________________________________________
|
Radio interface
Connector: 2 x 4 points removable screw connector ( Gnd PTT COR Rx Tx) - PTT : Open collector output (pull to Ground) (programmable active polarity) - COR : Reception indicator (direct open collector input pull to ground capability or logic level 3v to 15v capability (programmable active polarity) - Rx : audio Input impedance 100Ko (0 to 1.7Vac) (DC acceptance -14 to 14 V) - Tx : audio Output (0 to 1.7Vac)
Rx gain : adjustable from -6dB to 33dB Tx gain : adjustable from -33dB to 6dB Message gain : adjustable from -20dB to 8dB
Q.23 DTMF transceiver Maximum call duration timer: 1 to 255 mn
___________________________________________
Radio to Phone calls
Quick dial : DTMF dial from radio to select number in a list of 99 dial numbers Manual dial : DTMF manual dial from radio Direct dial : dial using the radio contact list
___________________________________________
Phone to Radio calls
Automatic mode: call is routed to a list of radios (5 radios, individual or group)
Manual mode: call is routed to radio which can be addressed by DTMF code (individual or group)
Mixed mode : manual & automatic mode behavior
___________________________________________
|